MOT Test



MOT Test
The quickest way to find your nearest MOT test station
  
  SEARCH FOR AN MOT TEST CENTRE IN 3 EASY STEPS                 
MOT TEST
SEARCH
FIND
mycarcheck - car data check
 

MOT Inspection
Manual Menu



Search this page
Search Manual
Lamps Positions Anti Locking Brake Systems Exhaust System
Headlamps Mechanical Brake components Exhaust Emissions - Spark Ignition - General
Brake Lights Hydraulic, Air and Vacuum Systems General Condition of the Vehicle
Reflectors Brake Performance (Roller Brake Test) Mirrors
Indicators Method of Calculating Brake Performance Fuel System
Headlamp Aim Ministry and Manufacturer's Plates Registration Plates and VIN Details
Steering Tyres Exhaust Emmisions
Parking Brake Tyre Size, Ply Rating and Load Index Tables Structural Integrity and Corrosion
Brake Efficiency Table Seat Belts Test Equipment
Hand Operated Brake Control Valves Windscreens/Drivers View of the road Vehicle Identification Number Location
Exhaust Emissions/Service Brake Control Audible Warning (Horn) Identifying Code Locations

1.4 Reflectors
Information Method of Inspection Reason for rejection
This inspection applies to: Obligatory rear reflectors only, that is, those required by regulations to be fitted. 1. Check that two red reflectors are fitted to the rear of the vehicle, symmetrically one on each side. 1. There are not two red reflectors facing to the rear or not fitted symmetrically, one on each side of the vehicle.
Exemptions
Rear reflectors are not required by regulations if the vehicle is not fitted with any front or rear position lamps etc. (see section 1.1). 2. Check that each reflector is a. facing to the rear 2. A reflector
a. not facing the rear
b. in good working order and clean condition b. not in good working order or in clean condition, ie so damaged or deteriorated that its function is impaired
Optional reflectors
Optional reflectors Any additional reflectors fitted to a vehicle other than reflectors required by regulations are not included in the inspection. c. not obscured  Note: At least 50% of the reflecting surface must be visible from the rear c. obscured
d. securely fitted d. insecure
Approval mark
The inspection does not include a check that reflectors have the appropriate approval mark. Reflective tape Reflective tape is not acceptable as a substitute for a rear reflector. e. not obviously incorrectly positioned Note: The precise position of rear reflectors is not part of the inspection, but visually check that all reflectors are at about i. the same height, and ii. the same distance inboard from the side of the vehicle e. obviously incorrectly positioned
PREVIOUS PAGE
NEXT PAGE
HOME

Reproduced from the MOT Inspection Manual by kind permission of THE VEHICLE INSPECTORATE.

   
MOT Test | Cookie Policy | Terms/Conditions
Copyright © 2004 - 2013 UKMOT.com. All rights reserved